From single components to full kits, find the right part for complete timing repair.
Belts, tensioners, pulleys, and kits designed for smooth, reliable performance.
Performance timing parts and kits for racing and high-output engines.
Durable timing and accessory products built for the toughest conditions.
INSTALLATION TIP To ensure proper performance of enclosed timing chain guide (Part # 9- 5181), guide should pivot freely after installation. Note: It is recommended to refer to…
TIMING CHAIN TENSIONER INSTALLATION ALERT GM 2.4L DOHC 1996-2006 This tensioner consists of two parts, the housing and the piston. The piston has a secondary piston or plunger…
GM has had different timing mark designs on both the timing and balance shaft chains. Independent of GM’s designs, Cloyes has designated the timing marks as shown in the illustrations to the right. With all designs…
GM has had 3 different tensioner designs. The 1st design had a rubber O-‐ring, had a larger tensioner piston, and was…
GM has had different timing mark designs on both the timing and balance shaft chains. Independent of GM’s designs, Cloyes has designated the timing marks as shown in…
INSTALLATION TIP The original cam sprocket (P/N 4448897) was redesigned by Chrysler. With a shorter hub, which required a thicker thrust plate. S-788T (P/N4778707) is a new kit…
Cloyes’ 9-keyway crank sprockets give the installer the ability to correct or re-position camshaft timing during engine assembly. As a general rule, retarding the cam timing will increase…
155 to 165
INSTALLATION TIP To ensure proper performance of enclosed tensioner (Part # 9-5179), supplied gasket is to be installed without the use of a sealer product. Note: It is…
INSTALLATION TIP To ensure proper performance of enclosed tensioner (Part # 9-5179), supplied gasket is to be installed without the use of a sealer product. To ensure proper…
INSTALLATION TIP The cam nose must be thoroughly cleaned before the sprocket is installed. The timing cover gasket must be used for correct spacing of the sensor. If…
INSTALLATION TIP To ensure proper performance of enclosed hydraulic tensioner (Part # 9- 5294), torque bolts to 8 – 10 n-m. (Torquing above 10 n-m. may warp aluminum…
155 to 160
You can see how this popup was set up in our step-by-step guide: https://wppopupmaker.com/guides/auto-opening-announcement-popups/
